HVAC Companies in Murfreesboro, TN

Searching "hvac murfreesboro" usually means one thing: something isn't heating or cooling right, and you want it fixed without spending an afternoon on hold. Cntrctrs sends one request to our network of licensed Tennessee HVAC pros, and you get three to five real quotes back — no cold calls, no showroom visits, no sales pressure.

Murfreesboro's housing stock skews newer, with a median build year of 2001 across 64,497 housing units, so most systems here were installed to modern sizing standards rather than patched over decades of duct rot. That shifts a lot of local demand toward capacity questions — is this unit big enough for our summer design load — instead of remediation, which changes what a fair quote actually looks like.

Prices below reflect what licensed contractors in the Murfreesboro area typically quote for common jobs. Actual cost depends on equipment tonnage, ductwork condition, and how quickly you need someone on site.

AC repair in Murfreesboro tends to land toward the low end when it's a capacitor or thermostat fix, and toward the high end when a compressor or evaporator coil is involved. Jobs move to the top of any range when equipment is oversized for the space, ductwork needs rework, or the visit falls during peak summer demand; older, harder-to-access units also add labor time even in a newer-built home.

Murfreesboro sees 38 days a year at or above 90°F and 45 days that drop to freezing, so total system failure during either stretch is a real emergency, not an inconvenience. No cooling during a heat run, no heat when nights fall below freezing, a gas smell, or visible refrigerant/water damage all justify calling for same-day service. A weak airflow vent, a noisy but functioning unit, or a scheduled tune-up can wait for a standard weekday appointment.

AC repair in Murfreesboro during a summer heat spike is the single most common after-hours call we route, since equipment sized to a 96°F design temperature can struggle on the hottest days if it's already undersized or low on refrigerant. Expect emergency or after-hours visits to carry a flat surcharge in the $100 - $250 range, sometimes billed as 1.5x standard labor rates.

• Emergency-worthy: no heat below freezing, no AC above 90°F, gas odor, water leaking into the home
• Can wait: minor noise, uneven airflow, routine filter or tune-up needs

When in doubt, describe the symptom in your request and the contractors who quote you will flag whether it's truly urgent.

The process is built to skip the part where you call five companies and wait on hold for each one. You describe the job once, and we take it from there.

1. Submit one request describing your HVAC issue or project.
2. We contact licensed local pros who match the job and area.
3. You receive 3-5 quotes within about 24 hours.

From there, you compare price, timeline, and scope, then choose who to hire directly. There's no obligation to pick anyone, and no repeated follow-up calls from contractors you didn't select.

Tennessee requires HVAC contractors to hold a license through the state Board for Licensing Contractors for jobs valued at $25,000 or more, and technicians handling refrigerant must carry EPA Section 608 certification regardless of job size. Most residential AC or furnace replacements in Murfreesboro fall under that state licensing threshold, but liability insurance and proper certification still matter on every job, and major equipment changeouts typically require a permit through the local codes department.

Tennessee sets the requirement by project value, and Murfreesboro sits in one of the counties carrying an extra rule. Statewide, work at or above the $25,000 threshold requires a contractor licence from the Board for Licensing Contractors with the mechanical classification. Below that, Rutherford County is one of the counties where a Home Improvement licence is required for smaller jobs, which most of the state does not require at all. Ask which of the two applies to your job and which one the contractor holds, then check it on the board's online licence search.

• Active Tennessee contractor license for jobs over $25,000
• EPA 608 certification for anyone handling refrigerant
• Current general liability insurance
• Permit pulled for full system replacements where required

How much does AC repair cost in Murfreesboro?

Most AC repairs run $150 - $600, depending on the part involved and whether it's a same-day call. A capacitor or refrigerant top-off sits at the low end, while a compressor or coil replacement pushes toward the top.

How fast can I get someone out for an HVAC emergency?

Many local contractors offer same-day service for true emergencies like no heat during freezing nights or no AC during a 90°F stretch. Expect an after-hours surcharge in the $100 - $250 range on top of standard repair costs.

What size AC do I actually need for Murfreesboro summers?

Equipment here is typically sized to a 96°F cooling design temperature with roughly 1,805 cooling degree days per year, so undersized units struggle on the hottest 38 days annually. A licensed contractor should size replacement equipment to your home's square footage and insulation, not just swap the old tonnage.

Do I need a permit to replace my furnace or AC unit?

Full system replacements in Murfreesboro generally require a permit through the local codes department, while like-for-like repairs usually don't. Contractors in our network typically handle the permit process as part of an installation quote.

Will my home's age affect my HVAC costs?

With a median build year of 2001 across the city, most Murfreesboro homes have systems sized to modern standards rather than decades-old ductwork. That means quotes here more often address capacity or upgrade questions than the duct rework common in older housing stock.

Is getting quotes through cntrctrs free?

Yes, submitting a request and receiving quotes costs nothing, and there's no obligation to hire anyone. You only pay the contractor you choose, directly, for the work performed.